DBC2000

- Employs a plug-in mounting method - Uses a microprocessor to improve performance - Status and fault indication by indicator LEDs - A 4-wire firing rate switching circuit controls an air damper motor or other auxiliary equipment duringstart-up of the burner. - Safe start check before and during pre-purge - Dual flame amplifier for UV, IR or flame rod sensor - Automatic recycle once per 24h of uninterrupted heat demand. - Frontal jack plug (Ø 3.5mm) to read the flame signal with a microampere meter. - An electrical sub base lock (reset and safety limit terminals are swapped) to avoid that a Standard model is used systems wired for an Enhanced or Ultimate model. The DBC2000 cannot start then. - Safety shutdown occurs on - Remote bus communication (Ultimate model only)